1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 120Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 120

DRC6001 STEPRUNNING OUTPUT TEST 1Twist and remove primary lead from ignition coil 2Use clockwise twist to install Stevens
meter red lead to terminal extenderConnect meter black lead to clean engine ground 6Start engine and run under load at RPM
where ignition problem exists: Meter must show 240 volts or higher If test shows low output, go to STEPCHARGE COIL TEST If
test shows no output, go to STEPIGNITION MODULE TEST7Remove terminal extenderInstall ignition coil primary lead Mirageeng