1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 136Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 136

26Remove both center main bearings and split sleeves from the crankshaft for inspection27Remove crankcase seal rings for
worn or lost, replace all 24 bearings during reassembly 32Remove the neutral detent retaining ring using small screwdriverRemove
the detent ball and springCleaning Before inspecting or assembling powerhead, all internal components must be perfectly clean
and free of contaminants1Remove any carbon accumulation from exhaust port areas 2Remove any carbon accumulation from cylinder
head combustion chambers3If cylinder walls are glazed from extended use, use medium grit cylinder hone to resurface wallsUse
slow RPM to achieve strong "crosshatch" pattern for best oil retention and ring sealing INote To avoid piston or cylinder