1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 137Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 137

rn 4.ofUse QJIC adhesives, and 0Nk: Gel-Seal" sealant from the Gel Seal Gasket Remover to remove all traces gaskets, and
components must be clean and free of excess oil2Make visual inspection of all internal componentsCheck for unusual wear patterns,
scuffing or deterioration of aluminum parts, heat-related discoloration of bearings and bearing surfaces, and broken components[]
3Check for cylinder head warpage using piece of bar stock or machinist's straightedge and feeler gauge set Cylinder head
warpage must not exceed 0.004 in(0,10 mm) end to endResurface or replace head if warpage exceeds this dimension[] 4Use micrometer
to measure the diameter of each crankpin and main bearing journalThe lower main bearing journal would only be measured if
the bearing was removed for another reasonRefer to Engine Specifications, Section 1, for dimensions 5Visually inspect crankcase
seal rings for worn, grooved, or chipped conditionIf they appear wornuse micrometer to measure their thickness Replace any