1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 140Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 140

4Lubricate new driveshaft a-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall a-ring in sleeve rn
the exposed lip of the seal into the lower housingPress against outer metal case of the seal until the edge of the metal
case is flush with the inside surface of the lower housing []] 9Coat the lower housing a-ring, a-ring groove, and flange
with OMC Gasket Sealing CompoundPlace the a-ring on the lower housing[]] 10Lubricate seal lip with outboard lubricant and
place lower bearing seal housing on crankshaft INote It is very important to notice that there is top to the pistons in this
engineAll pistons are marked with the word "UP"This side of the piston must face the flywheel, when the pistons are placed