1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 141Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 141

[] 12Lightly oil new a-ring with outboard lubricantInstall the a-ring onto the upper bearing and seal assembly 13Install
and wrist pin have looseloose fitNo tool is required to install the wrist pinDO NOT install wrist pin that will not easily
go into place in the pistonRemove any burrs or carbon deposits from around the wrist pin bore that could cause difficulty
installing the wrist pin 17Position the piston with the word "UP" on the piston dome facing upOil the wrist pin bore and
wrist pinInstall the connecting rod with the alignment marks or ave part number facing upInstall the wrist pin through the
piston and connecting rod, pushing the alignment tool out through the piston18Using ave Wrist Pin Retainer Installer, PI
342223, install new wrist pin retaining rings in each wrist pin holeGap of retaining ring faces 180, away from notch in piston19Repeat