1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 144Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 144

33Secure restraining jaw "G" and forcing jaw "H" to 34Tighten the rod cap screws to torque of 25-30 inIbs(2-3 Nm) 35Apply
rodThe groove lines on the jaws must be centered on the rodcrankpin diameter INote The above procedure must be followed to
assure frame is squarely in position[] 36Tighten the forcing screw to torque of 23 inIbs(2,5 Nm)37Loosen both rod cap screws
14 turn 38Apply preliminary torque of 40-60 inIbs(5-7 Nm) to both rod cap screwsrCia ;"s, 39Apply final torque of alternate
increments to both rod cap screws Nm) in two 40Loosen forcing screw and remove the frameRepeat Steps 36 thru 39 for remaining