1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 146Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 146

49Remove the backing from new intake manifold gasket and install it in place on the reed box side ofthe manifoldRefer to
throttlespark lever and the crankcase 52Apply OMC Triple-Guard grease to the inside and outside of the two throttle lever
bushings Install the bushings into the bosses on the crankcase [] 53Apply OMC Triple-Guard grease to the throttle lever shaft
and install it in the bushingsPlace the spacer on the end of the shaftPlace the throttle lev.er on the end of the shaft and
secure with flat washer and nut Tighten the nut to 60-84 inIbs(7 -9 Nm)54Remote Models: Apply OMC Locquic Primer to the two
trunnion anchor screws and allow to air dryApply OMC Nut Lock adhesive to the screwsAttach the trunnion anchor block to the