1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 171Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 171

Cleaning and Inspection 1Inspect clamp screw assemblyReplace swivel plate and retainer if bent or looseTo install new swivel
all oil seals, a-rings, and gaskets4Examine the rubber motor mounts and replace if deteriorated or damaged5Before checking
the exhaust housing for distortion, thoroughly clean the top and bottom mating surfaces and remove all sealer and corrosion
DR2351 OJ 6Check the exhaust housing for distortionPlace the hous- ing on surface plateUsing dial indicator, check flatness
by measuring the run-out on the top edge of the housingThe maximum allowable run-out is 0.009 in(0,228 mm)If you do not have
access to dial indicator and surface plate, seek the services of machine shopDO NOT attempt to straighten distorted housing;