1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 175Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 175

8Using punch and mallet, drive the steel pin that retains the inner handle from the steering handle INote Do not remove the
the steering handle components for wear, cracks, or damageReplace parts if necessary3Refer to Ignition System, Section 3,
to test stop switchAssembly 1Install the throttle cable seal in inner handle m 2at removedapply Loctite Depend 300 adhesive
to inner If handle areas shown rn 3Install the metal outer handle over the plastic inner handle and drive the outer handle
into placeOJ 4Secure tab of the inner handle into recess of the outer handle with the steel pin 5Install the handle end of