1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 200Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 200

20Remove and discard the propeller shaft bearing housing O-ring Note Inspect bearings in placeIf bearing is removed for any
lube to prevent rusting3Perform the following inspections Gearcase housingall gasket surfaces must be free of gasket materialAll
threaded holes must be free of corrosion and sealer Gearcase anodeif anode has been reduced to twothirds of its original
size, it must be replacedRefer to Section for testing procedure Driveshaftcheck splines for chips, wear, and cracksBearing
and gear surfaces must not show signs of metal transfer, corrosion, or discolorationSevere spline wear might indicate an
exhaust housing or geiucase has been distorted by impact damage Water intake screenmust be clearIf screen can't be cleaned,
it must be replaced All internal componentsmust be visually inspected for signs of wear, distortion, chipping, metal transfer,