1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 202Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 202

8Install the pinion bearings using the following components of ONIC Universal Pinion Bearing Remover and Installer, PIN
aBearingdriveshaft PIN 322923.inPress 9Oil new bearing CD the using ONIC Installer, bearing against the lettered side of
the bearing until the tool is seated on the bearing sleeveUsing the same tool attached to OMC Plate, PIN 318122, press the
bearing sleeve assembly into the gearcase until the plate contacts the gearcasePress against the lettered side of the bearing
when installing it into the gearcase rn [[] the sealsInstall Gasket Sealing Compound to driveshaft 10Apply OMC the metal
casing of new seals back to back in the bore using ONIC Seal Installer, PIN 326552Install the inner seal with flush lip facing
into the gearcase, then the outer seal with extended lip facing out of the gearcaseApply OMC TripleGuard grease to the seal