1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 206Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 206

32Using brass punch and mallet, seat the bearing housing in the gearcase rn 33Apply OMC Gasket Sealing Compound housing retaining
gauge Hold down firmly on the driveshaft and pump pressure up to 3-6 PSI (21-41 kPa)If pressure gauge indicates leakage,
submerge the gearcase in water to determine source of leakage as evidenced by bubblesIf the gearcase pressure does not indicate
leakage, increase pressure to 16-18 PSI (110-124 kPa).lf pressure does not hold, submerge the gearcase in water and check
for source of leakageMake necessary repairs and repeat the test Screw in vacuum testPump out 3-5 in(76-127 mm) of mercury
and see if vacuum holdsThen pump out 15 in(381 mm) of mercury and checkIf the gearcase fails to hold on either test, put