1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 208Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 208

6Move the shift lever until the upper shift rod engages the lower shift rod connectorWhile holding the lower shift rod connector,
hole Install and secure the cotter pin 9Install and position the trim tab as referenced during disassemblyInstall and tighten
the screw to 60-84 inIbs(7-9 Nm)If position is not known, see Trim Tab Adjustment in this section10Adjust the shift lever
and neutral start switch Trim Tab Adjustment Improper trim tab adjustment can cause difficult steering A propeller will generate
steering torque when the propeller shaft is not running parallel to the water's surfaceThe trim tab is adjustable to compensate
for this steering torqueA single trim tab adjustment will relieve steering effort under only one set of speed, motor angle,
and load conditionsNo single adjustment can relieve steering effort under all speed, motor angle, and load conditionsIf the