1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 211Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 211

2Apply 0v1C Gasket Sealing Compound to the threads of the single shorter mounting screw Install the screw into the hole in
screws into the two middle screw holes of the gearcase before the gearcase is installed Their length will not allow access
past the anti-ventilation plate once the gearcase is installedInstall the gearcase onto the extensionSee that the driveshaft
engages the crankshaftRotate the flywheel, if necessary[] 6Apply 0v1C Gasket Sealing Compound to the threads of the two remaining
long and two short gearcase extension retaining screwsInstall these screwsTighten all six screws to 192-216 in Ibs(22-25
Nm) 7Slide the upper connector half CD onto the upper shift rod Q) and install the plastic keeper 8Move the shift lever until
the upper shift rod engages the lower shift rod connectorWhile holding the lower shift rod connector, tighten the upper shift