1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 217Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 217

3Hold pulley in place and turn pulley slightly to check that spring is hooked to pulleySecure pulley with screw, lubricated
or long punch through pulley and starter housing to hold pulley in position against spring tension rn 6Thread rope through
handletight and assemble knotHeat and anchor retainer into rope and press end flatPull knot anchor into handle as shown []]
7Thread rope through rope guide, and through pulley rim and rope channel, to anchor point with sharp, hooked pinHeat rope
and press end flatKnot rope and pull tight into anchor point[]] 8Remove tool holding pulley, and let spring slowly wind rope