1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 226Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 226

Starter Circuit CheckAll Models Note I Battery must be fully chargedStep Procedure Remove black lead from ground at G) Connect
Steps thru Turn key OFF before connecting and disconnecting meterTurn key to START position after connecting bIf no reading,
go to Step II Check voltage between ground Connect meter at Turn key to START position aIf meter reads battery voltage, solenoid
is faultybIf no reading, go to Step II Check voltage between ground Connect meter at Turn key to START position aIf meter
reads battery voltage, lead is open between and or neutral start switch is open or improperly adjustedbIf no reading, go
to Step II Check voltage between ground Connect meter at Turn key to OFF position aIf meter reads battery voltage, check