1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 236Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 236

5If the pinion does not properly engage the flywheel, the pinion and shaft may be worndistorted, or dirty6Inspect and replace
with the recessed end facing the end of the shaftInstall the spring Install the upper spring retainer onto the shaft, with
the deeper recess facing the end of the shaft5Install the plastic cover onto the armature shaftPush the cover until it snaps
into place []] 6Place small amount of OMC Tripe-Guard grease on the end of the armature shaftSnap the retaining ring into
the groove at the end of the armature shaftMove the upper spring retainer into position to cover the retaining ring Wipe
away any excess OMC Tripe-Guard grease 7Install armature and end frame into starter housingAlign housing and end frame alignment