1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 259Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 259

Trim Gauge Troubleshooting INote To avoid immediate meter damage, never apply an ohmmeter to an electrical circuit where
switch ON, check for voltage at key switch "A" terminal: If voltage, check condition of remote control purple 16-gauge leads
If no voltage, check condition of key switch and engine harness 20-amp fuse 4Turn key switch OFFRemove trim harness leads
from gauge terminals "S" and "G"Calibrate an ohmmeter on low ohms scale and connect between the leadsTest results should
be: engine fully downapproximately 88 ohms, engine fully up approximately ohm: If your values are correct, replace trim gauge