1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 262Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 262

8Reinstall UP relayPush blades only halfway into UP (blue) end of bracket9Push UP trim button and check for voltage at V4
lead to clean engine ground, and voltmeter red lead to V7 (greenwhite) m 15Push control box DOWN trim button If no voltage
at V7check control box trim switch and wiring, and to to Step 16 If voltage at V7, go to Step 16 m 16Push lower motor cover
DOWN trim button If no voltage at V7check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck
for voltage at redpurple connector that supplies lower motor cover switch If voltage at V7go to Step 1717Reinstall DOWN relayPush
blades only halfway into bracket in DOWN (green) end of bracket18Push DOWN trim button and check for voltage at va (green)
on relay blade (M terminal of If no voltage at va, go to Relay Ohmmeter Test If voltage at va, go to Step 1919Disconnect
trim motor's blue and green power wire connector (leave relay in bracket)20Push DOWN trim buttonCheck for voltage on green