1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 55Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 55

11The neutral detent must be in NEUTRAL (center position) when the control lever is in NEUTRAL 12Remove the shift cable from
control cables and press grommet into groove in lower englne cover& 14Inspect installation to ensure that the control cables
are attached to the proper engine levers by lifting the fast idle lever to the START positionIf correctly attached, the throttle
cable and engine throttle lever will move Routing of Electrical CablesRemote Models & Disconnect battery cables from battery
before servicing electrical systemsFailure to do so could result in injury from electrical sparks or from contact with moving
parts if accidental cranking or starting occurs 1Apply OMC Triple-Guard grease to shaded area shown in figure 2Align arrows
and push connectors firmly together rn 3Secure the connectors with retainer rn4.Secure cablepositive (red) batteryCover terminalstarter