1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 56Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 56

6Reposition fuel" manifold to make room for the routing of electrical cables7Remove fuel connector bracket and lay to the
in position in the grommet 13Place battery cable into grommet with the flat side facing down14Place power tilt and trim electrical
cable starboard side opening of grommet 15In the opening, route the remote control electrical cable and VRO wires 16Lower
the grommet into position on the lower engine cover17Install fuel nipple and bracket assembly into position on the lower
motor cover and retain with screwPlace fuel manifold into its proper position &After installation, verify that there is sufficient
clearance for all cables to avoid binding or chafing through all engine steering and tilting anglesE Safety Related 45Cfeng