1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 83Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 83

VRO$ Component Servicing r:=J Anytime the VRO oil supply line has been disconnected from the engine, you must run 50:1 fuelloil
solvent to remove any contamination Install the filter, being careful not to move the pickup assembly on its support rods2With
the pickup assembly out of the reservoir, vacuum test the system to check for air leaks: Carefully, remove the oil hose from
pickup assembly and from engine oil inlet fitting Use low pressure air to purge hose of oil Use cap holder, PIN 329661to
plug pickup end of hose Attach vacuum tester to the engine end of oil line and draw inHg vacuumThe oil system is good if