1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 85Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 85

4Install and secure 10 in(25 cm) length of 14 in(6,35 mm) L.J I.Dclear vinyl hoseA few inches from the loose end, measure
putting light finger pressure on the outlet hose At 800 RPM, the oil level in your hose should drop in(25,4 mm) in approximately
five pulses At full throttle, the oil level in your hose should drop in(25,4 mm) in approximately three pulses7If your results
vary, check the pulse limiter fitting before replacing the pump8If you remove the pump, carefully cut the hose to avoid damaging
the fittingWhen installing, use ratchet clamp on the oil supply hoseTorque the screws, pump-to-bracket, to 18-24 inIbs(2-3