1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 95Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 95

8Check for correct positioning of float levelFloat level controls the height of fuel in the float chamber and is very critical
to dimension shownTo adjust, bend tab on float arm where tab contacts float seat Base of Carburetor Body Float Lever Tang
to achieve proper dimension into in(28-41 mm) 10Install float chamber and new gasket11Apply OMC Locquic Primer and OMC Screw
Lock to the threads of four float chamber screwsInstall the screws and torque in an "X" pattern to 25-35 inIbs(2,8-4,0 Nm)Installation
INotel Do not use sealer on carburetor gaskets& Replace any fuel hoses if deteriorated or damaged 1Install new carburetor
flange gaskets2Install primer hoses to carburetor nipples3Install carburetors on manifold studs, and secure with lock washers
and nuts4Install fuel hoses on carburetors, and secure, using new clamp and OMC Tie Strap Installation Tool, PIN 3237185Snap