1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 99Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 99

Assembly f411Place leaf valves on leaf plateIf new valves do not seat on L!.Jthe leaf plate, turn the leaf valves overUsed
near center of leaf stopDo not tightenf616Hold leaf valve assembly in horizontal positionThis will usually align leaf valves
over ports in leaf plateTighten the two screws evenly 07Use sharp pencil to mark the edges of leaf valves1sl8Use pencil eraser
to gently open the leaf valves to check the alignment of the valve over the portValves should be spaced evenly over portIf
not, loosen mounting screws and reposition leaf valve9After leaf valve is positioned properly, install remaining screwsTighten
all screws evenly to torque of 25-35 inIbs(3-4 Nm)10Apply OMC Locquic Primer and OMC Nut Lockto the leaf plate assembly to
manifold screws11Using new gaskets installed dry, position each leaf plate assembly and torque the screws to 25-35 inIbs(3-4