1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 120Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 120

Ignition Component Replacem entCD IIAmp ill twist and remove all spark plug leads'" 1To avoid accidental starting of engine
bullet connectors if necessary1al1gl9Route leads and install clamp I! wrap plateand spiral All component leads must be routed
through clamp and plate in single layer, not twisted or crossed over another lead10Apply OMC Nut Lock to the threads of the
five ignition plate screwsInstall the ignition plate on the retainer plateTorque five retaining screws to 25-35 inIbs(2,8-4,O
Nm)11 Check for sufficient slack on ignition component leadsRoute component leads through wire clampsr:JOl 12Position OMC
Locating Ring, PI 334994, over machined bosses on the ignition platePush the locating ring in toward the component to be
installedHold the ring in place and pull the component out toward the ringTighten screws to torque of 15-22 in Ibs(1 ,6-2,4