1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 136Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 136

16 DR4257 STEPRUNNING OUTPUT TEST 1Twist and remove primary leads from ignition coils 2Use clockwise twist to install Stevens
black lead to clean engine ground5Adjust voltmeter to setting listed in following chartStart engine and run it under load
at RPM where ignition problem existsMeter must show at least: Models 40RVV, RS, RP; 45,55 40RE, BA 12 Amp 6Repeat Step for
No.2 ignition coil: If either cylinder shows less than specified output, test charge coilRefer to STEPCHARGE COIL TEST If
charge coil tests good, replace the power pack7Remove terminal extendersInstall ignition coil primary leadsObserve proper