1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 163Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 163

1491 53Install starboard lower engine cover mount bracket and torque screws to 60-84 in Ibs(7-9 Nm) 54Install the complete
the l3J eight powerhead retaining screwsInstall and torque the screws to 18-20 ftIbs(25-27 Nm) f31 5Install the exhaust housing
to powerhead nutTighten the nut to 18-20 ftIbs(25-27 Nm) ill tighten the shift rod retaining screw 6Engage the shift rod
in the shift rod linkInstall and 7Perform all linkage adjustments and verify full advance ignition timing before returning
engine to customerRefer to Synchronization and Linkage Adjustments, Section 1 fN'=J To avoid permanent powerhead damage,
instruct operator to repeat the original engine break-in procedure as described in Section before putting engine back into