1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 192Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 192

1sl 3Mark the position of the water tube for correct reassemblyRemove the water tube cover screwsSeparate the water tube
to the outer exhaust housingf51 5Install the two lower side mounts to the exhaust housingTighten the screws to torque of
18-20 ftIbs(25-27 Nm)Install the thrust mount to the housing and tighteh the screws to torque of 60-84 inIbs(7-9 Nm) E.I
necessaryInstallation f51 6Check condition of the shift rod seal and replace if f11l 1Position the exhaust housing in the
swivel bracket assemblyApply OMC Nut Lock to threads of the upper mount screwsPosition the ground lead CD under the center
screwTighten the screws to torque of 18-20 ftIbs(25-27 Nm)f21 2Apply OMC Nut Lock to threads of the lower mount to lower
mount bracket screwsInstall and tighten the screws to torque of 18-20 ftIbs(25-27 Nm) rv 3Install the port and the starboard