1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 197Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 197

Install the steering friction thrust ringbevel side up in the swivel bracketThread the steering friction screw in the swivel
lower thrust washer in the lower mount bracketSlide the lower mount bracket on the splines of the pivot shaft while aligning
front of the mount bracket with the steering armInstall the retaining ring on the pivot shaft with sharp edge of ring facing
out13Lubricate the swivel bracket through the four lubrication fittings with OMC Triple-Guard grease136114Slide the steering
arm seal onto the steering arm with the word "TOP" facing upr::;;l15Position the upper rubber mount, the upper mount washersand
the retaining washers on the steering arm with the word "UP" on the mount facing upBe sure to place the ground lead between