1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 204Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 204

Water Pump Servicing If the gearcase has been in service for any length of time, it is good policy to install water pump
not pump water rn 3Place the a-ring in the groove in the impeller housing[] 4Lightly coat the exterior of the impeller cup
with OMC Gasket Sealing CompoundInstall the cup in the impeller housingThe cup locks in place in the housing with square
index tab Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for
impeller cam facing out 7Place the water tube grommet in the impeller housing with the inside chamfered edge facing upSecure
the water tube bracket to the impeller housing[[] 8Apply thin bead of OMC Adhesive Msealant to groove of the impeller housing
grommetPlace the grommet in position on the impeller housing 6Run thin bead of OMC Adhesive sealant in the seal groove, and