1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 214Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 214

2Slide the Collar, PIN 334985 (8), from OMC Driveshaft Shim Kit, PIN 433032, onto the driveshaft with large end touching
exceeds 0.004 in(0,10 mm)8Check the squareness of the pinion to the driveshaft by holding the gauge bar against the bearing
housing, between the screw holes, while rotating just the driveshaft and pinion assembly and measuring the clearance between
the gauge bar and the pinionReplace the gear set or the driveshaft, as necessary, and repeat the check if variance exceeds
0.002 in(0,050 mm) 9Subtract the average clearance measurement obta ined in Step from 0.030 in(0,762 mm) to determine the
correct shim thickness required Select fewest number of shims to achieve correct thickness10Remove the driveshaft from the
tool baseRemove the collar and bearing housing from the driveshaft and add the required amount of shims11 Check shimming
by reassembling the driveshaft with shims and placing it back into the tool baseThe measurement between the gauge bar and