1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 230Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 230

Propeller Shaft Bearing Housing Service 1261 1Remove both seals using OMCPuller Bridge, PI 432127, and OMC Large Puller Jaws,
behind bearing 12s1 3Remove front bearing using OMC Puller Bridge, PIN 432127, and OMC Bearing Puller, PIN 432130Rest puller
plate on top of housing to support bridge and tighten jaws securely behind bearing4Clean housing and bearings in solvent
and dry thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect
a-ring groove and sand off any sharp edges that would cut a-ring and prevent its sealing5Thoroughly clean the four bearing