1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 231Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 231

31 12911301 a;J=OR=20""'"62-J 7Oil, then install new bearings in the bearing housing using OMC Bearing Installer, PIN 326562
and housing must be replaced as an assembly1Remove the two driveshaft bearing housing seals using OMC Puller Bridge, PIN
432127, and OMC Large Puller Jaws, PIN 432129Discard the seals2Remove the a-ring from the bearing housing and discard 3Clean
the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove 4Install new seals back to back
in the bearing housing using OMC Seal Installer, PIN 326549Apply OMC Gasket Sealing Compound to the metal casings of the
seals before installingInstall the inner seal with flush lip facing toward the bearing housing, then the outer seal with
extended lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing5lightly
apply OMC Triple-Guard grease to new a-ring and install in its groove in the bearing housing COA3581 45C1on9 40RW, 40RP,