1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 234Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 234

Assembly r::=J Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable
it into the water intake cavity, and push it down as far as it will go with screwdriver or other suitable tool 1441451 ""
6To prevent personal injury, wear safety glassesInsert the spring and ball, coated with OMC Needle Bearing Assembly Grease,
into the housingPress the ball down with small pin punch until it is below the detent cross holePush the shifter detent over
the ball, withdraw the punch, and force the shifter detent in until it slides over the detent ball 14611471 7Place the shift
press the shifter detent all the way the lever in the housing, engaging shifter detent, and inNext, hold the cradle on the
shifter shaft with OMC Needle Bearing Assembly Grease, hook the cradle over the shift lever, and install the shift lever
pin 48 8Place the thrust bearing Q) on the shoulder of the forward gearPlace the thrust washer on the bearing housingUse