1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 244Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 244

Bearing Housing Assembly Servicing 1Remove water pump assembly from jet housing 2Remove four bearing housing retaining screws,
be 6Allow bearing housing to cool until it is warm to the touch 7Place bearing housing assembly in pressPress from the impeller
end of the driveshaft until the seal carrier is free from the housingContinue to press bearings and driveshaft from bearing
housing []] 8To replace the bearing housing seal, remove inner seal retaining ring with knife blade or thin-blade screwdriverLift
tang of retaining ring, and raise retaining ring in circular motion until it has been removed[]] 9Using punch, drive out