1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 246Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 246

18Remove thrust washer and collar Remove retainer ring if required driveshaft 19If removed, install retaining ring in groove
ring 21Using retaining ring pliers, install snap ring with sharp edge of it facing away from bearingMake sure the retaining
ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from
the pliers22Place spacer and seal carrier assembly onto the driveshaftApply OMC Triple-Guard grease to two new O-rings and
install on seal carrier23Fill bearing housing cavity with OMC Marine Wheel Bearing Grease 24Heat the bearing housing slightly