1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 261Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 261

r:J7l 8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley
the starter pawl plate Q) Press the other end of spring on the boss of the pulleyPosition the starter pawl plate on the pulleyf21l
13Clean threads of the starter pawl plate retaining screw and nut to remove adhesiveInstall the starter pawl plate retaining
screw Q) and washer into the starter housingTighten screw to torque of 120-144 inIbs(14-16 Nm)Spray threads of starter pawl
plate retaining screw that protrude through the starter housing and threads of the nut with OMC Locquic PrimerApply OMC Nut
Lock to the threads of the nutInstall and tighten the nut securely14Using the shoulder screw, install the rope guide to the
starter housingTighten the shoulder screw securely COA1375 1221 15If removed, install the starter handle bracket to the starter