1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 306Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 306

Trim Gauge Troubleshooting fN=J To avoid immediate meter damage, never apply an ohmmeter to an electrical circuit where voltage
ON, check for voltage at key switch "A" 3W!th If voltage, check condition of remote control purple 16-gauge leads If no voltage,
check condition of key switch and engine harness 20-amp fuse, PIN 510884 rv terminals liS" andOFFRemove trim harness leads
from gauge 4Turn key switch "G" Calibrate an ohmmeter on low ohms scale and connect between the leadsTest results should
be: engine fully downapproximately 88 ohms, engine fully up approximately ohm: If your values are correct, replace trim gauge