1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 327Get this manual

1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 327

Sending Unit Adjustment r,1 1The sending unit eccentric cam must be adjusted so that the gauge needle is aligned with the
the eccentric cam just forward of the top of the cam at about r:jl f31 5Loosen cam screw and rotate eccentric cam to adjust
full down gauge position: If the needle was above the lowest markmove the thick part of the cam TOWARD the contact point
Tighten the screw, and recheck the gauge reading If the needle was below the lowest markmove the thick part of the cam AWAY
from the contact point Tighten the screw, and recheck the gauge reading6Tighten eccentric cam retaining screw and check needle