1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 37Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 37

Submerged Engines Engine Dropped Overboard (Not Running)If engine is recovered from water immediately, it must be serviced
engine in horizontal position (spark plug openings down) and work out all of the water by slowly rotating flywheel approximately
20 times or until there are no signs of water5Drain carburetorsplace engine in upright position and remove carburetors for
disassembly and draining6Starters, electrical connectors, and all electrical equipment should be completely disassembled,
cleaned, flushed with fresh water, treated with water displacing electrical spray, and thoroughly dried before assembly7Inject
outboard lubricant into spark plug holes8Reassemble parts you removed and disconnectedStart engine (follow starting instructions)
and run 112 hour using the "break-in" fueloil mixtureRun the engine on "break-in" fueloil mixture for approximately three
hours after servicingSee Break-in Procedure in this sectionFor models with VRO$: if oil line has become disconnected, the
oil line must be purged and the system primed before any attempt is made to start the engineRefer to Section 2, OMC 9If engine