1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 42Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 42

Throttle Cam 1Attach the throttle cable to the throttle arm and secure throttle cable trunnion [IQJ 2Verify the throttle
and that there is approximately 0.010 in(0,25 mm) clearance between the throttle cam and cam followerWide Open Throttle Stop
1With the engine not running, manually advance the throttle lever to the wide open position in the carburetor shafts are
verticalRoll pins must not go past verticalIdle Timing 2Adjust the wide open stop screw so that the roll pins The boat and
engine must be in the water under normal operating conditions with the correct propeller installedThe boat's movement must
be unrestrainedThe boat must not be tied to dock or trailer1Reconnect the spark plug leadsConnect timing light to the No.1
cylinder spark plug lead2Start the engine and allow it to reach normal operating temperatureShift to FORWARD gearVerify the
throttle arm is against its idle stop 3The engine timing pointer must align with correct degree mark on the flywheel gridIdle