1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 44Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 44

50TTl, 60TTl, 65RS, 70TTl Synchronization and Linkage Adjustments - INote It is important that this step-by-step procedure
against the tool, mark the flywheel directly across from the pointerConsider this mark A"5Continue to turn the flywheel in
clockwise direction until the piston contact is felt again Mark this exact spot on the flywheel and consider this mark "8"Remove
the piston stop tool 6Use flexible scale along the flywheel edge and measure the midpoint between marks "A" and "8"Mark the
midpoint on the rim of the flywheelConsider this mark "C"If the mark "C" and the cast-in mark are in agreement, the timing
pointer alignment is correctIf not, proceed to Step 7 7Turn the flywheel to align the mark "C" with the pointerHold the flywheel
in this positionLoosen the pointer screw and move the pointer to align with cast-in mark on the flywheelTighten the pointer
screwsThrottle Cable Adjustment 1As you face the steering handle, turn the idle speed adjustment knob counterclockwise to
complete slow speed position 28e sure throttle cable bracket is secured to the powerhead using the forward mounting hole