1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 45Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 45

3Back out the idle speed screw screw until flush with anchor block and wide open stop IT] 4Turn the twist grip to full open
adjustmentTighten jam nut after correct adjustment is obtainedThrottle Plate Synchronization [] 1Loosen the cam follower
screw and push the cam follower away from throttle camThe follower MUST NOT touch the throttle cam during this procedure[]
2Loosen upper and lower carburetor linkage screws 3Verify that all throttle plates are closed lI9J 4Apply light upward pressure