1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 47Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 47

clockwise to achieve specified timing 5Repeat Steps and 3 & 4Stop the engineTo adjust, turn the idle speed screw INote This
and the clearance between the cam and follower is less than 0.010 in(0,25 mm), the adjustment is correct3If the adjustment
is not correct, turn the shell farther onto the link to increase the clearanceTurn the shell farther off the link to decrease
the clearanceWhen the proper clearance is achieved, snap the shell coupler onto the throttle cam ball4To test this adjustment,
rotate the twist grip to wide open throttle position, and then back to idle positionVerify the throttle arm is against its
idle stop and that there is approximately 0.010 in(0,25 mm) of clearance between the throttle cam and cam followerWide Open