1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 51Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 51

Shift Cable '2l1Extend shift grease 2Verify that the ' and lubricate with OMC Triple-Guard lever is down in the RUN position
the adjustment in Step 7, or if the gearcase detent does not correspond with remote control NEUTRAL in Step 10, refer to
Section for shift rod height adjustment i and washer supplied with engineTighten locknut 11Attach shift cable to shift lever
pin using locknut securelyWhen installing OMC Accessory Controls, except for prewired surface mount, the shift cable must
be adjusted and installed when the control and engine are in NEUTRAL12Slip rubber grommet onto control cables and press grommet
into groove in lower engine cover i attached to the proper engine levers by lifting the fast idle lever to the START positionIf
correctly attached, the throttle cable and engine throttle lever will moveWhen installing remote control that is not manufactured
by Outboard Marine Corporation, you must verify that the shift cable stroke is compatible with this engineThis engine is