1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 52Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 52

ill electrical Electrical Cable Installation I.A Disconnect battery cables from battery before servicing systemsFailure
to power- 1sl 7Manual Tilt ModelsInstall battery cables, electrical cable, and VRO Low Oil Warning wire in grommet Install
clamp and secure with two screwsrJl 8TrimTilt ModelsBundle the electrical cable, the trimtilt cable, battery cables, and
VRO Low Oil Warning wire, and wrap the cables using the piece of rubber wrap supplied with the battery cables Install tie
strap around rubber wrap Twist tie strap around so the connection is facing down to fit in lower engine cover Tighten and
cut tie strap Place rubber wrap in opening in front of lower engine coverInstall clamp and secure with two screws ill all
cables to avoid binding or chafing through all engine steering and tilting angles "'" After installation, verify that there