1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 68Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 68

6Test the "no oil" warning circuit Connect shop tank with 50: fueloil mix to the fuel inlet fitting Remove the protective
Install the oil hose on the oil inlet fittingUse only the ratchet clamp supplied with the kit to secure the lineTighten with
pliers To complete priming, squeeze oil primer bulb until oil is visible at the sight tube located in the oil hose near the
pump During break-in period, the engine's fuel tank must have operation 50: fueloil mixture in addition to Prime the oil
system before priming fue systemIf fuel system is primed first, the oil system must be primed with the engine idlingPrime
until oil is visible at the sight tube Warning pumphorn will sound until oil reaches the 8Store the protective cap removed
from the oil inlet fitting on the yellow cap holder attached to the fuel hose9The oil level must be marked on side of the