1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 70Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 70

Component Servicing Any time that the VRO oil supply line has been disconnected from the engine, you must run 50: fueloil
mild solvent to remove any contamination Install the filter, being careful not to move the pickup assembly on its support
rods 2With the pickup assembly out of the reservoir, vacuum test the system to check for air leaks Carefully remove the oil
hose from pickup assembly and from engine oil inlet fitting OJ Use low pressure air to purge hose of oilW Use cap holder,
PI 329661to plug pickup end of Attach vacuum tester to the engine end of oil line and draw inHg vacuumThe oil supply system