1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 72Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 72

3Carefully remove the oil supply hose from the pump's oil inlet fitting 4Install and secure 10 in(25 cm) length of in(6,35
the pump cycles by using fuel pressure gauge or putting light finger pressure on the outlet hose At 800 RPM, the oil level
in your hose should drop in(25,4 mm) in approximately pulses At full throttle, the oil level in your hose should drop in
(25,4 mm) in approximately pulses7If your results vary, check the pulse limiter fitting before repairing the pump8If you
remove pump, carefully cut the hose to avoid damaging the fittingWhen installing, use ratchet style clamp on the oil supply